With the exception of buying new dome lights and replacing them (which will take about 5 minutes per light), we are done with lighting changes. Finally. First off, if you haven't seen my other lighting posts, check out
number 1 and
number 2.
In my last post, I posted about the chandelier, as well as painting one of our fans. So first off, I finished the second fan. The first two times I painted light fixtures, I left them up on the ceiling, then just taped off around them. Spray paint fumes aren't fun, though, so after the success of my chandelier wiring (see post 2), I decided to unwire the fixtures and take them outside to spray paint. That went much more smoothly (though a bit difficult getting the fan back up on the ceiling - the wiring part was easy - the actual mounting proved a bit tricky). Here are the before and after of fan #2.
Next, I decided to tackle the bathroom lighting. As I mentioned in post #1, we had that Hollywood lighting in all our bathrooms, and I was looking for something nicer. So I purchased Hampton Bay Andenne light bars, via eBay and Amazon. As with most things you buy from sources like that, there were a few hiccups and a couple trips to Lowe's for additional parts. The half bath and the upstairs bath were both fairly straightforward. Turn off electricity, remove bulbs, pull out bulb holders, pull off face plate, then unscrew mounting plate from junction box, unwire light.
Then do it in reverse. Install mounting plate (though that was actually trickier than expected - I had to get creative with how I connected it - in the end, I bought different mounting plates than were supplied with the lights), wire light to wires in wall (also tricky with one of the lights which, turns out, was missing a wire - dang eBay) - black to black, white to white, ground to ground. Finally, attach light fixture to mounting screws and secure, pop in bulbs, turn power back on, and voila: light!
 |
| Half Bath |
 |
| Girls' Bathroom |
I still need to patch and paint, of course (stupid painting). The tricky part was when I decided to do the master bathroom, and replace one big (eight-light) light bar with two three-light fixtures. Because there was only one junction box originally, I had to move it and install another one. Which also meant running wire through the wall. I basically followed all the steps I found in
this blogger's post...mostly.
Because you see, when I decided where to put the lights, it just made sense that I would want to put them directly over the sinks, right? Well, I should have double checked that they would FIT right over the sink. Cuz...they didn't. Here's the process:
 |
| 1. Remove Lights / Cut Giant Hole in Wall and Holes in Studs / Put New Wire in Wall |
 |
| 2. Put Junction Boxes in Place / Pull Wires Through / Start Patching Drywall |
 |
| 3. Finish Putting in Drywall Pieces |
 |
| 4. Tape Drywall Joints |
 |
| 5. Mud Drywall (Not Pictured: Sand a Ton and Get Dust Everywhere |
 |
6. Attach wires to light fixtures, turn back on breaker, screw in bulbs, switch on lights, realize left lights aren't working, take everything apart and put back together and then apart again, realize one of the wires was loose, reattach everything again, then sing hallelujah when all the lights come on
7. (Not Pictured) Cry when you realize you should have held up the light fixtures to the wall before you did all that work, so you would know in advance not to put them too close to the wall, since the window shades won't fit where they are |
 |
| 8. Take everything back apart, cut some more holes, move the lights over a few inches, go through the whole process again, and breathe a sigh of relief that it's all done |
